Cisco Systems ASR1002 Quick Start Guide download pdf (Page 5)

Attach the Rack-Mount Brackets—Chassis Rear-Mounted

To install the rack-mount on a Cisco ASR 1002 Router for a rear rack-mount configuration, follow these steps:

Step 1 Locate the threaded ear holes in the rear sides of the chassis.

Step 2 Position the rear rack-mount bracket top hole with the chassis from the back (See Figure 2).Make certain that you hold

the rear rack-mount bracket with the ear holes facing outward and towards the rear of the chassis. Align the rack-mount

bracket to the side of the router.

Figure 2 Installing the Cisco ASR 1002 Router Rear Rack-Mount Brackets

Step 3 Insert and tighten the screws.

Step 4 Repeat Step 1 through Step 3 on the other side of the chassis.

This completes the procedure for attaching rear rack-mount brackets to the chassis. Continue to Four-Post Rack Installation,

page 5 or Two-Post Rack Installation, page 7.

Four-Post Rack Installation

Note We recommend that you allow at least 1 or 2 inches (2.54 or 5.08 cm) of vertical clearance between the router and any

equipment directly above and below it.

Rear rack-mount bracket ear and holes

Rear rack-mount bracket screws

Rear rack-mount bracket

280279

1 2 3 4 5 6 7 8 9 10 ... 35 36

No comments

Cisco Systems ASR1002 Quick Start Guide Page 5