Cisco Systems 8-Slot User Manual Page 137
- Page / 182
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
4-37
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove an MSC, FP, or LSP
Figure 4-27 shows the CRS-LSP front panel.
Figure 4-27 CRS-LSP Front Panel
Understanding the Alphanumeric LEDs
At one end of the faceplate, near an ejector lever, a line card has two four-digit alphanumeric LED
displays that show a sequence of messages indicating the state of the card.
Note It is normal for some displayed messages to appear too briefly in the LED display to be read.
Troubleshooting the MSC, FP, or LSP
If the installed or replaced line card fails to operate or to power up on installation:
1. Make sure that the card is seated firmly in the Cisco CRS 8-slot line card chassis slot. One easy way
to verify physical installation is to see whether the front faceplate of the MSC is even with the fronts
of the other cards installed in the card cage.
2. Check whether the ejector levers are latched and that the captive screws are fastened properly. If you
are uncertain, unlatch the levers, loosen the screws, and attempt to reseat the MSC.
3. Examine the Cisco CRS 8-slot line card chassis alarm LEDs on the RP to see if there are any active
alarm conditions.
4. Examine the Cisco CRS 8-slot line card chassis power distribution units (PDUs) to see whether the
chassis, as a whole, is receiving power.
Status LEDs
Use the status LEDs, located on the line card faceplate, to verify the correct installation of the card:
• When the card is properly installed, the Status LED turns green. If this LED is off, verify that the
card is installed correctly.
• When the Status LED is blinking yellow, a problem exists on the board.
• When the Status LED is off, the board state is unknown. Verify that there is power to the board by
looking at the indicators on the power module.
1 Status LED 2 Alphanumeric LEDs
246834
1
2
INSTALL
THIS SIDE
UP
- 8-Slot Line Card Chassis 1
- Installation Guide 1
- CONTENTS 3
- Contents 10
- OL-6256-17 10
- Objective 13
- Audience 13
- Document Organization 13
- Document Conventions 14
- Related Documentation 15
- Changes to This Document 15
- Card Chassis Overview 19
- Chassis Components 20
- Chassis Components 21
- CRS 8-Slot DC Rear 22
- CRS 8-Slot AC Rear 22
- CRS 8-Slot DC Front 23
- CRS 8-Slot AC Front 23
- Chassis Cable Management 28
- Chassis Cooling System 29
- Chassis Power System 30
- Safety Guidelines 30
- Power Systems Overview 33
- Basic Chassis Power Details 34
- Power Shown 36
- DC Power Systems 38
- Figure 2-5 DC Power Cable Lug 40
- AC Power Systems 43
- Fixed Configuration AC Power 44
- Components 45
- Installing a PDU 47
- Removing a PDU 49
- Installing DC PDU Cables 51
- Removing DC PDU Wiring 53
- Installing AC or DC PMs 72
- CISCO CRS-1 73
- Removing AC or DC PMs 74
- 2 222222 2 82
- Power Shelf 83
- Modular Configuration Power 86
- Installing a Lower Fan Tray 88
- Removing a Lower Fan Tray 91
- Installing an Upper Fan Tray 93
- Removing an Upper Fan Tray 94
- What to Do Next 100
- Associated Components 101
- Chassis Slot Numbers 104
- Cautions and Recommendations 105
- Processor PLIMs 110
- Figure 4-10 DRP Card 111
- Installing a Slot Cover 113
- Prerequisites 114
- Required Tools and Equipment 114
- Removing a Slot Cover 115
- Removing an Impedance Carrier 118
- Installing a Pillow Block 119
- Removing a Pillow Block 121
- What’s Next 122
- Removing a Switch Fabric Card 126
- Installing an MSC, FP, or LSP 129
- Removing an MSC, FP, or LSP 133
- Status LEDs 137
- 3 5 6 127 84 143
- 21 10 139 143
- Installing a PCMCIA Card 145
- Removing an RP PCMCIA Card 146
- Installing a PLIM 147
- Figure 4-33 Installing a PLIM 150
- Removing a PLIM 151
- Statement 70 153
- Troubleshooting the PLIM 154
- Installing the Front Cover 169
- Removing the Front Cover 171
- Card Chassis Specifications 173
- AC Input, Delta 3-phase 175
- AC Input, Wye 3-phase 175
- APPENDIX 177
- Route processor card 179
Related products and manuals for Network equipment chassis Cisco Systems 8-Slot
(12 pages)© 2020, manymanuals.com. All rights reserved. | 0.685 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals