Cisco Systems ASR1002 Quick Start Guide download pdf (Page 19)

Step 1 Turn on power. The green OK LED on the power supply turns on. (Both power supplies are required in the Cisco

ASR 1002 Router.)

Step 2 Listen for the fans; you should immediately hear them operating.

Step 3 During the boot process, observe the system LEDs. The power LED should be green. The STATUS LED lights yellow

to indicate booting and then green when Cisco IOS is running.

Table 3 provides information about the LEDs as the system starts.

Table 3 Cisco ASR 1002 Router LED Activity

LED Label LED Color In the Power Up State -Behavior Description

PWR Power Solid green All power requirements are within specification.

Off The router is in standby mode.

STAT System status Solid green Cisco IOS has successfully booted.

Yellow BOOT ROM has successfully loaded.

Red System failure.

CRIT Critical Solid red Critical alarm indicator. On at power up

MAJ Major Solid red Major alarm indicator.

MIN Minor Amber Minor alarm indicator.

LINK 10/100/1000 RJ-45 Flashing green Link activity indicator.

Off No link.

Solid green Link with no activity.

BOOT eUSB FLASH

BOOT (BootDisk)

Flashing green Activity indicator.

Off No activity.

CARRIER BITS Green In frame and working properly.

Off Out of service or not configured.

Amber Fault or loop condition.

**Built-in

4xGE SPA SFP

Port Status

4 LEDs total, one for each

SFP

Off Port is not enabled.

Amber Port enabled. Problem with the Ethernet link.

Green Port enabled and the Ethernet link is valid.

CC - PWR Embedded SIP power rail

status

Green If all power supplies within their tolerance specifications.

CC - STAT Embedded SIP current status Green Green only when the SPA drivers have started and are

running and all critical processes are running.

Yellow ROMMON is running and during the download and

boot.

Red A fault is detected or the card is powering up.

**The built-in Gigabit Ethernet ports on the Cisco ASR1002 Router support the same small form-factor pluggable (SFP) optical transceivers as the

5x1 GE SPA. For specific shared port adapter SFP compatibility listings, go to Chapter 1 at:

http://cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/install_upgrade/ASR1000/ASRspahw.pdf

Note that the Cisco ASR1002 built-in GE ports support only the SFP-GE-T but not the SFP-GLC-T.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comments to this Manuals

No comments

Cisco Systems ASR1002 Quick Start Guide Page 19

Comments to this Manuals

Related products and manuals for Chassis components Cisco Systems ASR1002