Cisco Systems MWR 1900 Installation Manual download pdf (Page 24)

3-2

Cisco MWR 1900 Mobile Wireless Edge Router Hardware Installation Guide

78-13982-02

Chapter 3 Installing the Router

Connecting the Console Terminal and Modem

Attaching the Brackets

Attach the mounting brackets to the chassis as shown, using the screws provided in the bracket kit.

Attach the second bracket to the opposite side of the chassis. Use a number 2 Phillips screwdriver to

install the bracket screws.

Four screws are required on each side. Figure 3-1 shows how the bracket is attached.

Figure 3-1 Attaching the Bracket

Installing the Router in the Rack

Install the chassis in the rack. Rack-mounting screws are not provided with the router. Use two screws

for each side (supplied with the rack).

Installing a T1/E1 Multiflex VWIC

If your MWR 1900 router does not have a T1/E1 Multiflex VWIC installed of if you need to install an

additional T1/E1 Multiflex VWIC, see the VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR Installation

Instructions.

Caution T1/E1 Multiflex VWICs do not support online insertion and removal (hot swapping). Before

inserting a card into the network module or router chassis, you must turn off electrical power and

disconnect network cables.

Connecting the Console Terminal and Modem

This section describes how to connect a console terminal and a modem to the router. You can connect

only a terminal to the console port. Use the auxiliary port with a terminal or a modem for remote access

to the router.

DSU

56K

NSO

UXILIAR

Rack-mount bracket

65785

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

No comments

Cisco Systems MWR 1900 Installation Manual Page 24