Cisco Systems MWR 1900 Installation Manual download pdf (Page 41)

A-3

Cisco MWR 1900 Mobile Wireless Edge Router Hardware Installation Guide

78-13982-02

Appendix A Troubleshooting

Reading the LEDs

Troubleshooting Modules, Cables, and Connections

Network problems can be caused by a module, cables or cable connections, or external devices such as

a modem, transceiver, hub, wall jack, WAN interface, or terminal. Check for the following symptoms to

help isolate the problem:

• Module is not recognized by the router.

–

Make sure the module is firmly seated in its slot.

–

Check the LEDs on the module. Each module has its own set of LEDs. For information on these

LEDs, see Reading the LEDs, page A-3.

–

Make sure you have a version of Cisco IOS software that supports the module.

• Module is recognized, but interface ports do not initialize.

–

Make sure the module is firmly seated in its slot.

–

Check external cable connections.

–

Make sure you have a version of Cisco IOS software that supports the module.

• Router does not boot properly, or constantly or intermittently reboots.

–

Make sure the module is firmly seated in its slot.

–

Check the router chassis or software. Refer to the Cisco Information Packet publication that

shipped with your router for warranty information, or contact customer service.

• Router boots, but the console screen is frozen.

–

Check the external console connection.

–

Verify that the parameters for your terminal are set as follows:

(a) The same data rate as configured for the router (9600 bps is the default)

(b) 8 data bits

(d) 2 stop bits

• Router powers on and boots only when a particular module is removed.

–

Check the module. Refer to the Cisco Information Packet publication that accompanied your

order for warranty information, or contact customer service.

• Router powers on and boots only when a particular cable is disconnected.

–

There may be a problem with the module or cable. Refer to the Cisco Information Packet

publication for warranty information, or contact customer service.

Reading the LEDs

The LEDs on the front panel of the router enable you to determine router performance and operation.

Figure A-1 shows the locations of the LEDs.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Cisco Systems MWR 1900 Installation Manual Page 41

Comments to this Manuals

Related products and manuals for Chassis components Cisco Systems MWR 1900