Cisco Systems IOS XR User Manual Page 133

  • Download
  • Add to my manuals
  • Print
  • Page
    / 282
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 132
Implementing IS-IS on Cisco IOS XR Software
How to Implement IS-IS on Cisco IOS XR Software
RC-117
Cisco IOS XR Routing Configuration Guide
DETAILED STEPS
Command or Action Purpose
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters global configuration mode.
Step 2
router isis
instance-id
Example:
RP/0/RP0/CPU0:router(config)# router isis isp
Enables IS-IS routing for the specified routing instance, and
places the router in router configuration mode.
You can change the level of routing to be performed by
a particular routing instance using the is-type router
configuration command.
Step 3
address-family {ipv4 | ipv6} [unicast]
Example:
RP/0/RP0/CPU0:router(config-isis)#
address-family ipv6 unicast
Specifies the IPv4 or IPv6 address family, and enters router
address family configuration mode.
This example specifies the unicast IPv6 address family.
Step 4
spf-interval {[initial-wait
initial
|
secondary-wait
secondary
| maximum-wait
maximum
] ...} [level {1 | 2}]
Example:
RP/0/RP0/CPU0:router(config-isis-af)#
spf-interval initial-wait 10 maximum-wait 30
(Optional) Controls the minimum time between successive
SPF calculations.
This value imposes a delay in the SPF computation
after an event trigger and enforces a minimum elapsed
time between SPF runs.
If this value is configured too low, the router can lose
too many CPU resources when the network is unstable.
Configuring the value too high delays changes in the
network topology that result in lost packets.
The SPF interval does not apply to the running of the
ISPF because that algorithm runs immediately on
receiving a changed LSP.
Step 5
ispf [startup-delay
seconds
] [level {1 | 2}]
Example:
RP/0/RP0/CPU0:router(config-isis-af)# ispf
(Optional) Configures incremental IS-IS ISPF to calculate
network topology.
Step 6
ispf startup-delay
seconds
[level {1 | 2}]
Example:
RP/0/RP0/CPU0:router(config-isis-af)# ispf
startup-delay 600
(Optional) Configures the time delay between the starting
of the IS-IS instance and the activation of ISPF.
Page view 132
1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 281 282

Comments to this Manuals

No comments