Cisco Systems 3000 Instruction Manual Page 160
- Page / 234
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
9-6
Cisco TelePresence System 3000
OL-14521-01
Chapter 9 First-Time Setup
Setting Up CTS Components
Troubleshooting Displays
Use Table 9-1 to troubleshoot problems with the images on the displays.
Ta b l e 9-1 Troubleshooting Chart for Display Problems
Problem Possible Cause Action
Cisco TelePresence 3000/3200
only
Power-on test indicates the
displays turn on in the
wrong sequence. The
normal power on sequence
is the left, center, then right
display screen.
Video cable is not connected to its
corresponding codec connector.
Ethernet cable from secondary
codec is not plugged into the
correct port on the primary codec.
Check that the cable from each
display is plugged into the correct
connector on its corresponding
codec.
Plug the video-to-video cable into
the display connector on the
correct codec, as follows.
• Plug the center display into the
primary codec.
• Plug the participant’s left
display into the left secondary
codec.
• Plug the participant’s right
display into the right
secondary codec.
No image. Power cable is not plugged in.
Power switch on the back of the
display is off.
Check power connections and
switches on each display.
No image. The display has no image when
you are between calls.
No image expected. Enable a
display test from the Web user
interface to place the displays in
test mode.
No image. Video cable is not connected. (CTS-1000 only) Check that the
LED is lit at the bottom front of
each display and is either green or
amber.
Contact Cisco technical support if
you are certain that the cabling is
correct and power is applied to the
system, but no image is seen on the
display.
- Assembly Guide 1
- Use & Care Guide 1
- Field-Replaceable Unit Guide 1
- CONTENTS 3
- Contents 4
- Introduction 9
- Conventions 9
- Guidelines 10
- Related Documentation 10
- Overview 11
- Chapter 1 Overview 12
- Chapter Organization 12
- Assembly Overview 13
- Conventions and Terminology 14
- Tools and Equipment List 15
- Tools and Equipment List 16
- Building the Display Assembly 17
- Figure 2-1 Leveling feet 18
- Figure 2-2 Codec Safety trays 19
- 18 - 22” (45.7 cm - 55.8 cm) 26
- Leveling Alignment Points 30
- Leveling Goals 31
- Apply the Black Buffer strips 36
- Figure 4-8 Light Cup bracket 47
- Figure 4-15 Four L-brackets 54
- Accessory Cabinet 65
- CTS3K-FUR-MAPLE 67
- Figure 5-3 Left Display shelf 68
- Figure 5-6 Accessory Cabinet 71
- Figure 5-8 Left Display shelf 73
- Figure 5-11 Accessory Cabinet 76
- Building the Table Assembly 77
- Miscellaneous Table Items 78
- Figure 4 Right Table segment 84
- Figure 5 Right-most Table Leg 85
- Figure 6 Center Table segment 86
- Figure 8 Left Table segment 88
- Figure 10 Left-most Table leg 90
- Attach the table door 91
- Figure 13 Accessory cabinets 93
- 22 23 24 97
- Figure 19 Right Table segment 99
- OL-14521-01 100
- Figure 23 Left Table segment 103
- Figure 25 left Most Table Leg 105
- Figure 26 Microphone Assembly 106
- Figure 28 Accessory cabinets 108
- Elements 109
- Projector Assembly 110
- Privacy Panel Assembly 110
- Codec Assembly 110
- Parts List 111
- Camera Target Assembly 112
- Switch Bracket 112
- Figure 7-1 Camera Assembly 113
- Figure 7-5 Projector Assembly 117
- Figure 7-6 Projector Assembly 118
- Figure 7-7 VGA Module 119
- Figure 7-12 Codec Assembly 124
- Figure 7-13 Codec Assembly 125
- Figure 7-14 Codec Assembly 126
- Figure 7-17 Speaker Assembly 129
- Figure 7-18 Speaker Assembly 130
- Figure 7-19 Speaker Assembly 131
- Parts List 135
- Table Leg Power 140
- Projector Power 140
- Table Leg Signal 141
- IP Phone Signal 141
- Microphone Signal 141
- Projector Signal 141
- VGA Peripheral 141
- Projector HD Video to Codec 142
- Microphones 144
- RJ45 Power over Ethernet 149
- HDMI connector 149
- First-Time Setup 155
- Figure 9-1 Bootup Completed 156
- Figure 9-2 System IP Address 157
- Setting Up CTS Components 158
- Setting Up the Displays 159
- Troubleshooting Displays 160
- Cisco TelePresence 3000/3200 160
- Setting Up the Cameras 161
- Up/down screw 162
- Left/right screws 162
- Rotation screws 162
- Setting Up CTS Components 163
- Show All Camera Targets 164
- Flipping the Video Image 164
- Focus the Camera 164
- Troubleshooting Cameras 166
- Setting Up the Speakers 167
- Setting Up the Microphones 167
- Troubleshooting Microphones 168
- Setting Up the Projector 169
- Other Devices 176
- Maintaining the Projector 178
- Powering Off the System 180
- Removing the Camera Cluster 180
- Uncrating and unpacking: 181
- Removing Audio Components 182
- Removing a Display Shelf 183
- Replacement Bulbs 192
- Replacing a Light Fixture 192
- CTS-AV-EXP 193
- CTS-PRJTR-BL-GEN1 195
- CTS-LIGHT-CTRL 199
- Replacing a Display Shelf 199
- Replacing a Display Shelf 200
- Replacing a Table Top Section 201
- Section Assemblies 205
- Assemblies 217
- 69-1835-01, CTS3K-M 229
- Equipment 231
- Australia 232
- Central Europe 232
- India, UAE, South Africa 232
- North America 233
- Switzerland 234
- United Kingdom 234
Related products and manuals for Unknown Cisco Systems 3000
Unknown Cisco Systems 3750 User Manual
(176 pages)
(176 pages)
Unknown Cisco Systems R4.1.x User Manual
(8 pages)
(8 pages)
Unknown Cisco Systems OL-4266-08 User Manual
(124 pages)
(124 pages)
Unknown Cisco Systems MDS 9100 User Manual
(70 pages)
(70 pages)
© 2020, manymanuals.com. All rights reserved. | 0.590 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals