Cisco Systems 3000 Instruction Manual Page 161

  • Download
  • Add to my manuals
  • Print
  • Page
    / 234
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 160
9-7
Cisco TelePresence System 3000
OL-14521-01
Chapter 9 First-Time Setup
Setting Up CTS Components
Setting Up the Cameras
The cameras are set up correctly when images are centered and in focus on the display screens and the
white balance has been configured. The hardware setup software provides a camera Auto Adjust feature
and a way to use targets to fine-tune the camera’s focus.
Attach the Camera Target
Two camera targets are provided with the Cisco TelePresence system: a large white target and a smaller
target. You attach the large white target to the table prior to performing Auto Adjust (white balancing).
Attach the large Camera target to the corresponding Table segment, with the clamps matching the
counterbore feature under the table. Center the target on the edge of the table and standing vertical with
the clamps underneath the table holding it tight. The target pattern should face the camera.
Start the Software Setup
From the Hardware Setup page under Troubleshooting, click the Camera radio button.
Click Start to begin the camera setup. You should see output from each camera in the appropriate
camera display area.
Click Setup under the image of a display screen to begin adjustments for the camera focused on that
screen.
If you need further information about testing or adjusting this device, click Help in the content area or
see the troubleshooting charts in this section.
Note Make sure that the table edge is between the hash marks on both sides of the display.
Auto Adjust
After attaching the large white camera target to the table, click Auto Adjust.
This action allows software to adjust the camera settings automatically. You will see various images
and colors on the displays during the adjustment. Auto Adjust takes approximately 20 seconds.
Align the Camera
Click Show Camera Target.
Using the zoom ring on the camera lens, and the left/right, up/down, and rotation adjustment screws
on the camera, perform the following adjustments:
Make manual adjustments to the camera focused on the target to align the red plus sign to the
center plus sign on the target.
For the center display, zoom and align the camera so that the curved lines on each side of the
target touches the sides of the display.
For the left display, zoom and align the camera so that the curved line on the right side of the
display touches the red adjustment line at the right edge of the display to corresponding lines
on the target. On both sides of the display, you will see two small red hash marks. Adjust the
camera so that the edge of the table is positioned vertically exactly between the hash marks on
either side of the display.
See Figure 9-3 for the location of the adjustment screws on the camera. See Figure 9-4,
Figure 9-5, and Figure 9-6 for the correct placement of the curved lines and plus signs on the
camera target.
Page view 160
1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 233 234

Comments to this Manuals

No comments