Cisco Systems 3000 Instruction Manual Page 187

  • Download
  • Add to my manuals
  • Print
  • Page
    / 234
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 186
11-9
Cisco TelePresence System 3000
OL-14521-01
Chapter 11 Field-Replaceable Unit Guide
Replacing a Speaker—Part Number CTS-LDSPKR
c. After you have created a gap of approximately 1/2 inch (1 centimeter) between the screen and
the display shelf, detach the holes on the top screen from the locating pins on the underside of
the display shelves and remove the screen.
If your projector screen does not have side trims and is flush with the display cabinet, grasp the outer
edges of the screen and pull it up and away from the Projector clips that hold the screen to the
Display shelves.
Step 2 Disconnect the Speaker cable clips from the Speaker terminals.
Step 3 Remove the magnetically-held face plate cover from the speaker. You can pry the cover off by carefully
inserting the tip of a small screwdriver blade under the edge.
Step 4 Loosen the corner screws on the speaker with a 9/64-inch Allen wrench. The white fasteners on the rear
side of the Speaker board should end up in a horizontal, releasing position.
Step 5 Pull the speaker out and set it aside.
Step 6 Insert the replacement speaker and secure it in place.
Step 7 Power on the system by turning the power switches to the On position on the two left PDUs, single right
PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.
Step 8 Connect the Speaker cable clips from the Speaker terminals.
Step 9 Open a browser on a computer connected to the network.
Step 10 Type in the IP address of the Primary codec. Enter the required information at the login screen. The
Cisco TelePresence Administrator window appears.
Step 11 Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is Enabled/Up.
Step 12 Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
properly.
Refer to the Cisco TelePresence System Administrator's Guide for your software release for more
information.
Step 13 Reattach the projector screen.
Tip The projector screen comes with printed instructions that should assist you with replacing it. If you
cannot find the instructions, reverse the order of removal to install it.
Step 14 Perform the speaker test. See Chapter 9, “Setting Up the Speakers” for more information.
Page view 186
1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 233 234

Comments to this Manuals

No comments