8-15
Cisco TelePresence System 3000
OL-14521-01
Chapter 8 Routing Power and Signal Cables
Parts List
Step 11 Connect the camera assembly cables.
Figure 8-12 Cabling the Camera assembly
Note The camera cluster can experience radio frequency interference issues if the camera Ethernet and video
cables are routed, bundled, or tied together. Cisco recommends that you route the Ethernet and video
cables separately and use cable ties to tie them to opposite sides of the frame.
Figure 8-12 displays the rear view of the Cisco TelePresence System 3200. Left and right are reversed.
Tip Before you plug cables into a Codec, label each cable.
RJ45 Power over Ethernet
HDMI connector
201188
10
5
Comments to this Manuals