Cisco Systems 3000 Instruction Manual Page 193

  • Download
  • Add to my manuals
  • Print
  • Page
    / 234
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 192
11-15
Cisco TelePresence System 3000
OL-14521-01
Chapter 11 Field-Replaceable Unit Guide
Replacing the Audio/Video Extension Unit—Part Number CTS-AV-EXP
Step 3 For the right and left vertical light fixtures, follow these steps.
a. Remove the screws from the light fixture holding bracket. The bracket is located in the middle of
the fixture. Retain the screws.
b. Lift the light fixture up and out of the lower cup bracket.
Step 4 For the horizontal light fixtures, follow these steps.
a. Using the step stool or a small step ladder, reach over the display and remove the two screws from
the light fixture holding bracket. The bracket is located in the middle of the fixture.
b. Lift the light fixture up and out, being careful the cable does not mar the surface of the display.
Step 5 Place the replacement light fixture in the bracket and secure with the screws.
See Chapter 4, “Building the Lighting Assembly” for more information.
Step 6 Plug the light fixture into the PDU or Auxiliary Control Unit.
Step 7 Turn the power switch on the PDU or Auxiliary Control Unit to the On position.
Replacing the Audio/Video Extension Unit—Part Number
CTS-AV-EXP
To remove and replace the audio/video extension unit for the Cisco TelePresence 3000, you need the
following tools and equipment:
Medium Phillips head screwdriver (for attaching the unit to its bracket)
Large Phillips head screwdriver (for attaching the unit and bracket to the display structure)
Masking tape
Remove and replace the audio/video extension unit by performing the following procedure:
Step 1 Power off the system by completing turning off the following units:
The two left PDUs on the left accessory cabinet
The single right PDU on the right accessory cabinet
The auxiliary control unit on the center display structure
Caution Make sure all system power is turned off before beginning this disassembly.
Step 2 Remove the cables from the audio/video extension unit. Label each cable with masking tape for
identification as it is removed.
See Chapter 8, “Routing Power and Signal Cables” for additional information.
Step 3 Use the screwdriver to remove the two screws that attach the extension unit and remove the unit from
the display structure.
Step 4 Attach the new audio/video extension unit to its bracket, then attach the unit and bracket to the display
structure. See Figure 7-15 and Figure 7-16 for more information.
Step 5 Attach the cables to the new extension unit using the masking tape labels as a guide.
Page view 192
1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 233 234

Comments to this Manuals

No comments