Cisco Systems 3000 Instruction Manual Page 169

  • Download
  • Add to my manuals
  • Print
  • Page
    / 234
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 168
9-15
Cisco TelePresence System 3000
OL-14521-01
Chapter 9 First-Time Setup
Setting Up CTS Components
Setting Up the Projector
This section contains the steps that you perform to set up the projector and includes the following
sections:
Standard CTS-3000 Projector Setup, page 9-15
Projector Setup With an Auxiliary Control Unit, page 9-19
Standard CTS-3000 Projector Setup
To set up a projector with a standard CTS-3000 installation, complete the following steps:
Note The following procedures are specific to the Sanyo PLV-Z4 and PLV-Z5 projectors.
Step 1 Start a test pattern display for the projector by completing the following steps:
a. Open a browser that is connected to the network.
b. Enter the IP address of the primary codec to log in to Cisco TelePresence System Administration.
Note If you need to obtain the IP address, complete the following steps:
1. On the IP phone, locate Manual at the bottom of the screen and press the Manual soft key.
Note If you cannot locate the Manual button, proceed to Step 2.
2. Locate Info at the bottom of the screen and press the Info soft key.
3. Scroll down to the IP Address listing and copy the address.
c. Log in to the system by entering the following information:
Username: admin (case sensitive)
Password: cisco (case sensitive)
d. Select Troubleshooting > Hardware Setup, then click the Presentation Devices radio button.
e. Select the Test Pattern radio button.
f. Click Start to begin the test.
Step 2 Turn on the projector by turning the projector power/rocker switch to the ON position.
The projector takes approximately 15-30 seconds to warm up, and should be fully initialized within one
minute. If the projector is not receiving video, the screen will be blue. If the projector does not receive
video for five minutes and 30 seconds, the projector turns off.
Note The image is upside down and reversed since the projector is mounted upside down under the table.
If the test pattern is displaying correctly, you should see a grid projected on the projection surface. In
the center of the grid, you should see a series of horizontal grey bars. You should also see a one-pixel
wide green border around the outside of the grid.
Page view 168
1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 233 234

Comments to this Manuals

No comments