Cisco Systems 3000 Instruction Manual download pdf (Page 200)

11-22

Cisco TelePresence System 3000

OL-14521-01

Chapter 11 Field-Replaceable Unit Guide

Replacing a Display Shelf

Note Make sure to retain all screws, connectors, and other parts during the disassembly.

Removing and Replacing a Display Shelf Row Table Section

Step 1 Power off the system by completing turning off the following units:

• The two left PDUs on the left accessory cabinet

• The single right PDU on the right accessory cabinet

• The auxiliary control unit on the center display structure

Caution Make sure all system power is turned off before beginning this disassembly.

Step 2 Open the table door.

Step 3 Remove the Projector screen by performing one of the following actions:

• If your projector screen is slightly recessed and uses black side trims, complete the following steps:

a. Remove the side trims from the edges of the display.

Be careful not to mar the screen when you perform this step.

b. Use an open-ended wrench to loosen the feet on the bottom of the screen, and lower the screen.

c. After you have created a gap of approximately 1/2 inch (1 centimeter) between the screen and

the display shelf, detach the holes on the top screen from the locating pins on the underside of

the display shelves and remove the screen.

• If your projector screen does not have side trims and is flush with the display cabinet, grasp the outer

edges of the screen and pull it up and away from the Projector clips that hold the screen to the

Display shelves.

Step 4 Disconnect the speaker cables from the speaker terminals.

Step 5 Loosen the half-turn bolts on either side of the speaker boards.

Step 6 Slip the speaker boards over the half-turn bolts and remove them from the work area.

Step 7 From the underside of the display structure, remove all the screws that attach the display shelves to the

display assembly.

Note The Display shelves are attached individually to the display structures as illustrated in Figure 5-3,

Figure 5-4, and Figure 5-5.

Step 8 Loosen the draw bolts and remove the connecting plates that attach the display shelf to be replaced to its

adjoining shelf or shelves.

Note See Figure 5-2 for the draw bolt and plate locations.

Step 9 Slightly separate the shelf to be replaced from the other shelves.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 233 234

No comments

Cisco Systems 3000 Instruction Manual Page 200